RAID Battery

Removing a RAID Battery

WARNING: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. Before you begin this procedure, review the safety instructions that came with the system.

1Turn off the system and attached peripherals, and disconnect the system from the electrical outlet and peripherals.

2Rotate the system feet inward and lay the system on a flat surface.

3Open the system. See "Opening the System" on page 85.

4Disconnect the RAID battery cable from the connector on the integrated storage card.

Press the tab on the RAID battery cable connector, and gently pull the cable connector out of the connector on the storage card. See Figure 3-21.

5Pull the battery carrier release tab, and pull the battery carrier upwards and out of the battery carrier slots on the chassis. See Figure 3-21.

6Pull back gently on the two tabs holding the RAID battery in the battery carrier and draw out the RAID battery from the battery carrier. See Figure 3-21.

Installing System Components

127

Page 127
Image 127
Dell T710 owner manual Removing a RAID Battery, 127