Dell T710 E122A, E122C CPU Power, Fault. Power, Cycle AC, E122D Memory, Regulator #, DIMMs, Fan

Table 1-1. LCD Status Messages (continued)

Code	Text	Causes	Corrective Actions
E122A	CPU # VTT	Specified processor VTT	Reseat the processor(s).
	Regulator	voltage regulator has	See "Troubleshooting the
	failure.	failed.	Processors" on page 179.
	Reseat CPU.		If the problem persists,
			see "Getting Help" on
			page 193.

E122C CPU Power	A power fault was
Fault. Power	detected when powering
cycle AC.	up the processor(s).

Remove AC power to the system for 10 seconds and restart the system.

If the problem persists, see "Getting Help" on page 193.

E122D	Memory	One of the memory	Reseat the memory
	Regulator #	regulators has failed.	modules. See
	Failed. Reseat		"Troubleshooting System
	DIMMs.		Memory" on page 167.
E122E	On-board	One of the on-board	Remove AC power to the
	regulator	voltage regulators failed.	system for 10 seconds and
	failed. Call		restart the system.
	support.		If the problem persists,
			see "Getting Help" on
			page 193.
E1310	Fan ## RPM	RPM of the specified fan	See "Troubleshooting
	exceeding	is outside of the intended	System Cooling
	range. Check	operating range.	Problems" on page 166.
	fan.
E1311	Fan module ##	RPM of the specified fan	See "Troubleshooting
	RPM exceeding	in a specified module is	System Cooling
	range. Check	outside of intended	Problems" on page 166.
	fan.	operating range.
E1313	Fan redundancy	The system is no longer	Check LCD for
	lost. Check	fan redundant. Another	additional scrolling
	fans.	fan failure would put the	messages. See
		system at risk of over-	"Troubleshooting a Fan"
		heating.	on page 166.

About Your System

27