15Rotate the system feet outward.

16Replace the front bezel. See "Installing the Front Bezel" on page 85.

17Reattach any peripherals and connect the system to an electrical outlet.

18Turn on the system and attached peripherals.

Power Distribution Board (Service-Only Procedure)

Removing the Power Distribution Board

WARNING: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. Before you begin this procedure, review the safety instructions that came with the system.

1Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.

2Remove the power supplies. See "Removing a Power Supply" on page 82.

3Rotate the system feet inward and lay the system on a flat surface.

4Open the system. See "Opening the System" on page 85.

5Remove the system board. See "Removing the System Board" on page 152.

6To remove the power distribution board:

a Remove the two screws securing the power distribution board plate.

b Slide the power distribution board plate towards the front on the system and lift it out.

c Remove all the cable connectors from the power board.

d Remove the five screws securing the power distribution board to the plate and lift out the power distribution board.

156

Installing System Components

Page 156
Image 156
Dell T710 owner manual Power Distribution Board Service-Only Procedure, Removing the Power Distribution Board