Dell T710 owner manual Removing the Internal SD Module, 121

7Place the system upright and on its feet on a flat, stable surface.

8Rotate the system feet outward.

9Reattach any peripherals, then connect the system to the electrical outlet.

10Turn on the system and attached peripherals.

Removing the Internal SD Module

WARNING: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. Before you begin this procedure, review the safety instructions that came with the system.

1Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.

2Rotate the system feet inward and lay the system on a flat surface.

3Open the system. See "Opening the System" on page 85.

4Disconnect the internal SD module cable from the module and from the system board.

5Lift upwards on the latch securing the internal SD module to the chassis, then lift the module out of the chassis. See Figure 3-18.

6Close the system. See "Closing the System" on page 86.

7Place the system upright and on its feet on a flat, stable surface.

8Rotate the system feet outward.

9Reattach any peripherals, then connect the system to the electrical outlet.

10Turn on the system and attached peripherals.

Installing System Components

121