Paradyne 6800 manual Opening the System 5000 Host, System 5000 Ð Cover Fasteners

Preparing the Processors

Opening the System 5000 Host

To open the Altos System 5000 and install the memory and circuit cards, you will need a # 2 Phillips screwdriver and a .25I nut driver. Once you have these tools, perform the following steps:

CAUTION

1.Make sure the ac power cord is not connected to the System 5000 before opening the computer and attempting to perform any field installation activity.

2.To prevent static discharges that may damage the hardware, wear a ground strap or otherwise ground yourself to the chassis before opening the computer and installing any circuit cards.

1.Using the # 2 Phillips screwdriver, loosen the two screw-type fasteners (locking pins) that secure the cover to the chassis. The fasteners are located on the rear panel near the right side edge, as shown in Figure 2-1.

0 1

Screw-type

Locking Pins

491-13841

Figure 2-1. System 5000 Ð Cover Fasteners

6800-A2-GN22-30 January 1997 2-5