Paradyne 6800 manual Type DCPDIAG2

COMSPHERE 6800 Series Network Management System

14.Power down the processor and remove the IPC-1600 card. Reset the memory address from A0000 to its original setting as shown in Figure 2-14 for an Altos 5000 or Table 2-6 for an Altos 15000. Replace the card and power-up the processor.

Emulex DCP-286i Diagnostic Program

(for Altos 5000 Systems Only)

To run the diagnostic program that comes with the Emulex DCP-286i card, you need the disk entitled DCP286i Diag Disk Rev A that is shipped with the card and a bootable MS-DOS disk. With these items, perform the following steps:

1.Move the RESET/RUN key on the front panel clockwise to the RUN position to reboot the System 5000 (if the System 5000 is turned off at this point, move the power switch on the rear panel to the ON position instead). The System 5000 will run through its normal power-up sequence and display the following message:

Press spacebar to interrupt autoboot

2.PRESS: the spacebar immediately

The Boot Menu displays (see Figure 8-1).

3.Insert the bootable MS-DOS disk into disk drive and select Option 2 to boot from the floppy.

4.Once the System 5000 has booted, insert the disk entitled DCP286i Diag Disk Rev A into the disk drive and

TYPE: DCPDIAG2

PRESS: Enter

The diagnostic's Main Menu displays, with the highlight positioned on the option Run.

5.To run the program, PRESS: Enter

When the program finishes, the system returns to the Main Menu.

6.To exit the program and return to MS-DOS, highlight Exit and PRESS: Enter

8-12 January 1997 6800-A2-GN22-30