Paradyne 6800 manual Second and Third Hard Disk Jumper Settings

Preparing the Processors

Preinstallation Steps for the Automatic Backup and Restore Package

To prepare the third hard disk for installation on the System 5000, refer to Figure 2-4 and perform the following steps:

1.Locate the terminating resistor socket marked CN6 and remove the terminating resistor, if there is one present. The System 5000 does not use a terminating resistor.

2.Locate the jumper switch block marked as CHN1 and set the jumpers as shown in Figure 2-4.

3.Locate the jumper switch block marked as CHN7 and set the jumpers as shown in Figure 2-4. The CHN7 switch block must set the drive's SCSI ID to 2.

	SCSI
	ID
	1
	2
Power
Connection
	CNH7
	CNH1
Data	CNH6
Connection
	494-14505-01
	Terminating Resister Socket
	(must be empty)

Figure 2-4. Second and Third Hard Disk Jumper Settings

6800-A2-GN22-30 January 1997 2-9