Paradyne 6800 manual Bit, 8NONE, 9600

COMSPHERE 6800 Series Network Management System

5.When you have changed all necessary MENU1 settings, you are ready to access the second SETUP function Ð HARDWARE. To do this, press the FF button again. The message

HARDWARE

will appear in the display area. The HARDWARE function consists of 13 individual printer settings. These settings are shown below, along with the correct value for each setting (only eight of the settings apply to a parallel connection).

SETTING	SERIAL	PARALLEL
SPEED	:NORMAL	:NORMAL
PPR-OUT	:DETECT	:DETECT
PRT-DIR	:BI-DIR	:BI-DIR
BUZZER	:ON	:ON
WORD-LG	:8 BIT	:8 BIT
BUFFER	:8KBYTE	:8KBYTE
FEEDER	:NONE	:NONE
INTRFCE	:SERIAL	:PARALLEL
FORMAT	:8NONE 1
BAUD-RT	:9600
PROTOCOL	:XON/XOF
DSR	:IGNORE
DUPLEX	:FULL

6.Follow the procedure described in Step 4 to scroll through the HARDWARE settings and compare them to the correct settings shown above. If any of the settings are incorrect, follow the procedure in Step 4 to change them.

7.Once the MENU1 and HARDWARE settings are correct, you must save them (if you do not save them, your selections will be lost when the printer's power is turned off). To do this, press the FF button until the message

FUNCTN:SAVE

appears in the display area. Then press the RESET button. The message

SAVING NOW!!

will appear, followed by the message

FUNCTN:SAVE

8.The modified settings have now been saved in the printer's memory. Press the ONLINE button to return the printer to the ONLINE mode. The message

ONLINE:READY

will appear in the display area.

3-4 January 1997 6800-A2-GN22-30