Paradyne 6800 manual Opening the Altos 5000 UIP, Installing Additional Memory on the System

COMSPHERE 6800 Series Network Management System

Table 2-3

Altos 5000 UIP Factory- and Field-Installable Circuit Cards

Slot	Card	Memory	IRQ	I/O Address	Description
		Address
1	Base I/O	Ð	Ð	1000Ð101F	Controls the hard disk(s), floppy
					disk and cartridge tape drives.
	Integral	Ð	10	1CD0Ð1CD2	Supports connection to host, full-
	Ethernet				feature workstations. Incompatable
					with Token ring card.
3	Video	A0000ÐC7FFF	±	46E8,3B0Ð3DF	Provides VGA-level graphics.
6	Proteon ProNet	Ð	10	Ð	Optional. Provides support for
	Token Ring				Token Ring local area network
	Card				communication with hosts and full-
					feature workstations. Incompatible
					with Integral Ethernet.
8	IPC-1600	E10000ÐE1FFFF	11	110Ð11F	Optional. Provides 16 serial ports.

* The IPC-1600 is required on UIP-1 with Altos 15000 host.

Opening the Altos 5000 UIP

The procedures for opening the System 5000 UIP are the same as for the System 5000 host. Refer to the section, Opening the System 5000 Host, for precise instructions.

Installing Additional Memory on the System 5000

The UIP shipped with Release 4.2 has 32 megabytes of memory. If that UIP is connected to an Altos 15000 host, it requires an additional 16 megabytes. Upgrading from a prior release of NMS may also require additional memory to be installed (see Table 2-4).

To upgrade the memory on the Altos 5000 UIP, you must have a Single Inline Memory Module (SIMM) package, part no. 555-24231-003, which contains four 4 megabyte SIMMs. Converting from prior NMS releases may require more than one SIMM package.

Install the additional SIMMs, one SIMM in each of the four memory banks on the card, immediately next to those SIMMs already installed. If the SIMMs are not adjacent to each other in each bank or a memory bank has no SIMMs installed, the processor cannot power up properly.

To install the memory on the UIP, perform the following steps:

1.If the processor is running, stop the NMS processes and shut down UNIX by following the steps in the applicable sections of Chapter 6, System Start-up and Shutdown.

2.When the message Safe to power off appears, power down the processor using the on/off switch.

3.Remove the side cover, exposing the installed boards.

2-22 January 1997 6800-A2-GN22-30