Paradyne 6800 manual Hardware Configuration Menu Installing Unix on UIP

Loading and Restoring Software

The menu in Figure 5-8 appears:

Please specify Hardware Configuration:

1.Hardware configuration I (Single hard disk - UIP)

2.Hardware configuration II (Two hard disks - NMS HOST)

3.Exit Installation

Please enter your choice [1-3]:

492-13956

Figure 5-8. Hardware Configuration Menu (Installing UNIX on UIP)

6.For the UIP, TYPE: 1 PRESS: Enter

In response, the system sets the operating system environment, configures the hard disk, creates a UNIX partition, and divides the partition into file systems and swap space. When this is complete, the following message appears:

Altos UNIX System V Operating System Serialization

When prompted, use the serial number and activation key included with the Altos System V Operating System distribution

Enter your serial number or enter q to quit

TYPE: the UNIX serial number (found on the Serial Number card attached to the Release Notes)

PRESS: Enter

7.The following message appears:

Enter your activation key or enter q to quit

TYPE: the UNIX activation key (found on the Serial Number card attached to the Release Notes)

PRESS: Enter

NOTE

If either the serial number or activation key is entered incorrectly, the system prompts you again for the information. If you quit at either of these steps, you must start the installation process from the beginning.

6800-A2-GN22-30 January 1997 5-43