Paradyne 6800 manual To exit the configuration process, Type

COMSPHERE 6800 Series Network Management System

NOTE

The total number of local terminals configured determines the number of 6800 Series NMS cut-through sessions to an individual ANALYSIS NMS. The following rules apply:

NUMBER OF LOCAL TERMINALS	NUMBER OF CUT-THROUGHS ALLOWED
1	5
2Ð6	6Ðnumber of local terminals

On the ANALYSIS side, you will be asked as a part of the syssetup procedure to enter the number of permitted cut-throughs. It is important that you enter the same number during that procedure as is calculated in this step.

For example, assume you have two local terminals attached to your ANALYSIS NMS. Enter 2 in this step and the config6510 program will determine that four cut-through sessions are permitted (6 minus 2 = 4). On the ANALYSIS NMS side, you should enter 4 when prompted by the syssetup program for the number of cut-through sessions. (For additional information, refer to the ANALYSIS 6510 Automated Network Management System Reference Manual).

5.The system prompts you to confirm the information entered in the previous steps.

Is the information correct [y or n, q to quit]? TYPE: y (if the displayed information is correct) PRESS: Enter

6.The database is updated and your selection is confirmed with the following message:

Please wait... ªsystem nameº added to system where system name is the name entered in Step 2.

7.To exit the configuration process, TYPE: 4

PRESS: Enter

8.To add more 6510 configurations, return to Step 1.

5-96 January 1997 6800-A2-GN22-30