Paradyne 6800 manual Network Hub Unit

Connecting the Components

Allied Telesis CentreCOM™ MR810T

IEEE 802.3 10 BASE T

8 PORT MICRO REPEATER WITH AUI

1	2	3	4	5	6	7	8
PORT
							ACTIVITY	COLLISION	POWER
PORT OK
RECEIVE

8		7		6		5		4		3		2		1
	x		x		x		x		x		x		x		x

Allied Telesis

CentreCOM™ MR810T

IEEE 802.3 10 BASE T

MICRO REPEATER WITH AUI

493-14257

Figure 4-4. Network Hub Unit

Once you have this equipment assembled, perform the following steps:

1.Connect the network hub unit power cord to a non-switched outlet.

2.Connect the AUI adapter to the Ethernet card on the host processor.

3.Connect one end of a 035-0116-5031 cable to the AUI adapter.

4.Connect the other end of a 035-0116-5031 cable to a port on the network hub unit.

5.Connect one end of a 035-0116-5031 cable to the jack on the EtherLink II card in the full-feature workstation.

6.Connect the other end of the 035-0116-5031 cable to a port on the network hub unit.

NOTE

To ensure that the TCP/IP network operates efficiently, always use the shortest cord possible to connect each device to the network hub unit.

6800-A2-GN22-30 January 1997 4-7