Paradyne 6800 manual Type

Preparing the Processors

4.Remove the memory board by unscrewing the hold-down screw on the board in memory Slot 0 located at the bottom of the processor; gently pull the board until it is free of the slot. Place the board on a flat surface with its memory plug facing you.

5.Each of the four memory banks on the board should already have a memory SIMM installed in the first and second positions. Install each of the new 4 megabyte SIMMs as follows:

a.Hold the SIMM over the SIMM socket on the memory board with the SIMM's ªkey notchº located at the bottom and facing opposite the memory plug. This is the only way the SIMM can fit into the socket.

b.Firmly press the SIMM into the socket.

c.When the SIMM is seated properly in the socket, tilt it back with the pegs showing through the guide holes; press firmly until it snaps into place with the plastic arms on each side of the socket holding it securely.

CAUTION

If any difficulty is encountered in fitting the SIMM into the socket, getting the guide pegs into the guide holes on the SIMM, or snapping the plastic arms securely in place, you may have the SIMM facing the wrong direction, or it may be the wrong part.

6.Reinstall the memory board into memory Slot 0 in the processor from which it was removed by gently pushing it back until it is firmly seated in the slot.

7.Screw the hold-down screw back into the processor.

8.Replace the processor side cover, tighten down the screws, and power on the processor with the on/off switch.

9.When the system boots, the following messages appear:

Invalid configuration information - please run SETUP program

Select [1] to boot from Hard Disk

Select [2] to boot from Floppy

Select [3] to boot from Tape Select

[4]to enter BIOS setup Enter option:

TYPE: 4

6800-A2-GN22-30 January 1997 2-23