Paradyne 6800 manual Starting Unix on the UIP, Starting the UIP Application Program

COMSPHERE 6800 Series Network Management System

Starting UNIX on the UIP

To start the UNIX operating system, perform the following steps.

1.With the RESET key in the RUN position, turn on the power switch on the System 5000. The UNIX system will proceed to boot, and as it boots it will display a series of self-check and diagnostic messages on the console screen. After these messages have displayed, the following message displays:

Type CONTROL-d to proceed with normal start-up (or hit return for system maintenance):

2.To select normal start-up, press the Ctrl and d keys simultaneously.

3.The boot process will continue. When the system has fully booted, the login prompt displays on your screen.

Starting the UIP Application Program

Once UNIX has been started, you can start the UIP application program. To do so, perform the following steps:

1.At the login prompt: TYPE: uip PRESS: Enter

2.In response, the password prompt displays.

TYPE: the UIP password (the default UIP password is startmenu)

PRESS: Enter

The Network Management System Menu displays (Figure 6-5).

Network Management System

Select:

1)Start the system

2)Stop the system

3)Shutdown UNIX

4)Install PTF

5)Return to Console login

Enter number [1,2,3,4,5]:

494-13959-01

Figure 6-5. Network Management System Menu

6-8 January 1997 6800-A2-GN22-30