Paradyne 6800 manual Release 4.2 NMS Software, Installing the NMS Software

Loading and Restoring Software

The system confirms the following:

Altos/SCO Multi-Processor Extensions (MPX) has been loaded.

You must reboot the system before MPX will be active. Once you have rebooted, you can verify that multiple processors are working by logging in as root and typing ªuname-Xº, and looking for the ªNumCPUº field. It should say, ªNumCPU=2º. This means the system is using 2 CPUs.

Please type ªinit 6º to reboot the system.

13.When the UNIX prompt, #, appears: TYPE: init 6

PRESS: Enter

The system automatically reboots.

Release 4.2 NMS Software

This section explains how to install the Release 4.2 Network Management System (NMS) application program on an Altos System 5000 or Altos System 15000 computer.

You must install the software in multi-user mode.

To install the 6800 NMS Application Software on the host processor's hard disk, you need the following:

•A floppy disk labeled 6800 NMS Application Volume 6

•A cartridge tape labeled 6800 NMS Application Volume 7

Installing the NMS Software

To install the NMS Software, perform the following steps:

1.At the unix login,

TYPE: root (enter password, if any)

NOTE

The system cannot be installed from any other user login.

2.Set the system date and time by entering the command date MMDDhhmmyy

where MM is the month, DD the day, hh the hour (24-hour system), mm the minute, and yy the last two digits of the year (this is optional).

6800-A2-GN22-30 January 1997 5-21