Paradyne 6800 manual UIP Software, Etc/tz

COMSPHERE 6800 Series Network Management System

UIP Software

The section describes the steps to install the UIP software into the Altos System 5000. The UNIX software must be installed before the UIP software is installed. If adding the optional IPC-1600 card to the UIP, you need to reload the UNIX and UIP software (refer to the earlier section on loading the UNIX Software for the UIP.)

NOTE

If the UIP was previously installed and active, you must first stop it via the uip login, then select Option 2, Stop the System, from the NMS Main Menu.

To install the UIP software, you need the floppy disk labeled 6800 UIP Application Volume 6 and the tape labeled 6800 UIP Application Volume 7.

1.At the UIP login, TYPE: root PRESS: Enter

NOTE

The system cannot be installed from any other user login.

2.Set the system date and time by entering the command date MMDDhhmmyy

where MM is the month, DD the day, hh the hour (24-hour system), mm the minute, and yy the last two digits of the year (this is optional).

3.Set the proper time zone by entering the command

/etc/tz

The system prompts:

Are you in North America? (y/n) TYPE: y (as appropriate) PRESS: Enter

The system displays a list of time zones for the area, North America if you answered y to the question above, and prompt:

Enter the number that represents your time zone of enter q to quit: TYPE: the number of the appropriate time zone

PRESS: Enter

5-50 January 1997 6800-A2-GN22-30