Paradyne 6800 manual NAP Speed

COMSPHERE 6800 Series Network Management Systems

5. If the control processor's LED display shows a 2, perform the following steps:

NOTE

If this is a dual- or redundant-control processor configuration, the impact of this failure is less damaging. Even so, perform the following steps to correct the fault as soon as possible.

a.Check the control processor configuration using the Display Multiplexer Components Configuration (dsmcc) command. If the control processor was taken out-of-service due to failed diagnostics, go to the next step.

b.Check the alerts for a control processor failure. The alerts display on the network monitor or network map.

6.If the control processor's display shows a 9, make sure that the control processor's Enable/Disable switch is set to Enable. If the switch is set correctly, the control processor may have failed or its fuse may have blown. Contact your service technician for assistance. Refer to your multiplexer service manual for ordering information.

7.If the control processor's LED display shows a lowercase t followed by a two-digit trouble code, this indicates a sanity fault. If the trouble code remains after a power-up or a reset, write down the code and contact your service technician. For information on these codes, refer to your 740 or 745 ACCULINK Multiplexer Service Manual, as appropriate.

NAP Speed

If a command is sent to the first node and the following alert is issued,

Node XXX: No response received within an acceptable time Ð try again later.

check the NAP speed. Communication cannot occur if the NAP speed is incorrect. To check the NAP speed, do one of the following:

•If you are using a 74x multiplexer, check the NAP configuration at the multiplexer and change it, if necessary.

•If you are using a 719 NETWORKER, at the ASCII terminal connected to the 719, check the configuration via the 719 menu.

C-8 January 1997 6800-A2-GN22-30