Paradyne 6800 manual System prompts for the value of the starting I/O address

Loading and Restoring Software

3.After the searches are complete, the system displays the message:

Confirm

The current system configuration will support only 1 IPC-900 board. If installation

continues, 1 board will be configured.

Strike ENTER when ready or ESC to stop.

To continue, PRESS: Enter

4.The system prompts for the values to configure the IPC-900 card:

Please enter the following system configuration information for IPC-900 board;

The available interrupt(s) for the IPC-900 Board are:

IRQ 2

IRQ 3 (default) IRQ 5

IRQ 10 IRQ 15

Type the interrupt number and strike the ENTER key or type Q to cancel installation. Striking ENTER alone will

select the default. For the IRQ, TYPE: 5 PRESS: Enter

NOTE

The list of available IRQs as well as the I/O addresses and memory addresses is determined dynamically. Depending on the boards installed in the host, the IRQ, I/O and memory, output may vary. However, the installer should always enter the values listed in this install script.

5.The system prompts for the value of the starting I/O address:

Please enter the following system configuration information for the IPC-900 board:

The available starting I/O address for the IPC-900 Board are:

Starting I/O address: 2A0

Starting I/O address: 2B0

.

.

.

Starting I/O address: 3E0

6800-A2-GN22-30 January 1997 5-91