Paradyne 6800 manual Installation of the Token Ring Network Interface Card

COMSPHERE 6800 Series Network Management System

Installation of the Token Ring Network Interface Card

To install the optional ProNet p1392 Network Interface card (NIC) in the full-feature workstation, refer to Figure 2-28 and perform the following steps:

1.Power down the workstation.

2.Remove the workstation's cover; follow the manufacturer's instructions to expose the internal circuit cards.

3.Remove the 3COM EtherLink II card or any other network interface card(s) that may already be installed in the workstation.

4.Ensure that the p1392 on-board switches for the I/O address are in the factory default positions as indicated by Table 2-9.

5.Insert the ProNet Model p1392 NIC into the selected slot. Make sure that the card is firmly seated in the bus interface slot.

6.Secure the card in the processor using the saved screw.

7.Replace the workstation's cover.

8.Attach the unshielded twisted pair (UTP) cable to the RJ45 port on the installed ProNet NIC.

9.Attach the other end of the cable to the site's MAU.

Table 2-9

Token Ring I/O Address Switch Setting

I/O				Switches
Address	1	2	3		4	5	6
0A20	ON	ON	ON		ON	ON	ON

2-52 January 1997 6800-A2-GN22-30