Paradyne 6800 manual After each line. When complete, Press F6

COMSPHERE 6800 Series Network Management System

7.You are now ready to copy the IPC-900 diagnostic onto the newly formatted disk. To copy the diagnostic device drivers and programs, at the A>: prompt:

TYPE: copy a:*.* b:*.*

a.The system prompts you to insert a disk in the drive. Insert the disk entitled Intelligent Ports Card MS-DOS Device Drivers and Diagnostics Version 3.09 into the drive and

PRESS: Enter

b.The system will eventually prompt you to insert a disk in Drive B. Remove the diagnostic disk, insert the newly formatted disk into the same drive, and

PRESS: Enter

Steps a and b will alternate until the entire disk has been copied.

8.You now have to create a config.sys file to allow the IPC device drivers to be automatically loaded when the system is booted. To do this, at the A:> prompt,

TYPE: copy con: config.sys

The cursor will advance to the next line and await input. At this point, whatever you type on the keyboard will be put into a buffer and then written to a file named config.sys. Enter the following lines into the config.sys file

TYPE: device=ipc.drv /2B0,D2000,0 buffers = 10

files=20

and

PRESS: Enter

after each line. When complete, PRESS: <F6>

PRESS: Enter

to signal end of input; ^ Z will appear on the display.

9.With the newly created diagnostic disk in the drive, boot the system to load the device drivers. At the Boot Menu (Figure 8-1) select Option 2 to boot from the floppy. During reboot you should see messages referring to the driver for the IPC-900. (For more detailed information, refer to the AT&T Intelligent Ports Card Model 900 (IPC-900) User's Guide.)

8-6 January 1997 6800-A2-GN22-30