Paradyne 6800 manual Selection menu for board type appears

COMSPHERE 6800 Series Network Management System

10.Instructions for selection of values for the Proteon board then appear.

If you are using a p189x or p199x board, you must configure the board using the system's reference disk.

If you are using a p139x board, command line options are used to configure the iobase, interrupt vector, etc.

This utility will help you by editing these command line options into the config.sys file for you.

Press ENTER to continue; ESCAPE to go back to previous selections. To continue,

PRESS: Enter

11.The selection menu for board type appears:

Select the type of board you are using.

p139x ± p1390,p1391, or p1392 p189x ± p1890 or p1892 p199x ± p1990

Using the ↓↑ keys, select p139x ± p1390,p1391, or p1392 and PRESS: Enter

12.The system prompts for the Interrupt Vector with a default of 5. PRESS: Enter

13.The system prompts for the DMA Channel with a default of 5. PRESS: Enter

14.The system prompts for the Base I/O Address with a default of 0A20. PRESS: Enter

15.The system prompt for transmission speed. Use the ↓↑ keys to select either 4 Mbps or

16 Mbps, depending on the speed of any existing Token Ring network or the site standard, and

PRESS: Enter

16.The system prompts for the type of cable you are using. Use the ↓↑ keys to select either UTP for unshielded twisted pair or STP for shielded twisted-pair, depending on whether you have installed the RJ45 cable or the Token Ring coaxial cable, and

PRESS: Enter

17.A confirmation window appears for the preceding selected values and the system prompts:

Satisfied with your selections?

Press ENTER to continue; ESCAPE to change selections

5-80 January 1997 6800-A2-GN22-30