Paradyne 6800 manual Customized Network Configuration

Loading and Restoring Software

Customized Network Configuration

Where the NMS will be installed at a site with an existing local area network, the Network Administrator there may require that the NMS node names and IP addresses follow the standards of that site. This custom installation is also required for the Altos 15000. If the NMS has not been factory installed, the node names and IP addresses can be set during the normal NMS installation procedures. For processors where the NMS software has been factory installed, the host and UIP processors can be modified using netconfig, a program designed for just this purpose. On full-feature workstations the GrafPoint X-One software must be reinstalled following the instructions in this chapter and setting the IP address at the proper point in the installation process.

For the 15000 platform, the IP address and node names must be entered via one custom method. If one existing local area network is not a constraint, the values in Table 5-2 should be entered.

Table 5-2

Altos 15000 Basic Network Configuration Parameters

	Processer	IP Address	Node Name
6800	NMS host processor	1.1.1.1	unix
6800	UIP 1	1.1.1.2	uip-1
6800	UIP 2	1.1.1.3	uip-2
1st full-feature workstation		1.1.1.4	ws1
2nd full-feature workstation		1.1.1.5	ws2
	.	.	.
	.	.	.
	.	.	.
24th full-feature workstation		1.1.1.27	ws24

6800-A2-GN22-30 January 1997 5-5