Paradyne 6800 manual Printers, NMS Printer Models Function

COMSPHERE 6800 Series Network Management System

To establish the connection, perform the following steps at the processor end:

1.At the host processor or UIP end, connect the grounded end of a 035-0153-0031 cable to an available port on the IPC-1600 card. If connecting to a COM port, use the 002-0054-0031 connector.

2.Connect the other end of the 035-0153-0031 cable to the 002-0039-0031 connector.

3.Connect the 002-0039-0031 connector to the local DCE device.

4.At the remote end, connect one end of the 835-3564-2511 cable to the remote DCE device.

5.Connect the other end of the 835-3564-2511 cable to the workstation 25-pin serial connector on the basic-feature workstation.

Printers

There are five model printers available for the COMSPHERE 6800 Series NMS as shown in Table 4-2.

Table 4-2

NMS Printer Models

Function

Model

System Printer

Fujitsu DL5600 or DL3400/DL3600

Alert Log Printer

Fujitsu DX2300 or C.ITOH C-240

Dedicated Automated Trouble Report Printer

Fujitsu DX2300 or C.ITOH C-240

Chapter 3, Preparing the Printers, explained that preparing the printers for connection to the host processor involved modifying some of the default strap settings on each printer to conform to NMS requirements. If you have not done this, read Chapter 3 and follow the instructions for modifying the settings.

Once you have modified the settings, you can connect the printers to the host processor. Figure 4-12 provides an overview of the different ways each printer can be connected. The following sections provide instructions for connecting each printer.

4-18 January 1997 6800-A2-GN22-30