WARNING
Fire Risk or Explosion Hazard.
•Gas
•Purge should be performed by a qualified technician.
•Ensure adequate ventilation.
• Ensure there are no ignition sources such as sparks or open flame.
•A small amount of air will be in the gas supply lines. When first lighting appliance it will take a short time for air to purge from lines. When purging is complete the appliance will light and operate normally.
Air only needs to be purged again if gas valve has been turned to the OFF position.
WARNING
CHECK FOR GAS LEAKS
Explosion Risk.
Fire Risk.
Asphyxiation Risk.
•Check the fittings and connections
•Do not use open flame.
•After the gas line installation is complete, all connections must be tightened and checked for leaks with a
off all leak check solution following testing. Fittings and connections may have loosened during shipping and handling.
WARNING
Fire hazard.
Do NOT change the valve settings.
•This valve has been preset at the factory.
•Changing valve settings may result in fire hazard or bodily injury.
HIGH ALTITUDE INSTALLATIONS
When installing this appliance at an elevation above 2000 feet, it may be necessary to decrease the input rating by changing the existing burner orifice to a smaller size. Input rate should be reduced by 4% for each 1000 feet above a 2000 foot elevation in the U.S.A. If the heating value of the gas has been reduced, these rules do not apply. To identify the proper orifice size, check with the local gas utility.
If installing this appliance at an elevation above 4500 feet (in Canada), check with local authorities.
Page 28 | Heat & Glo · Tiara Petite B · | August 1, 2008 |
