6 Gas Information
A. Fuel Conversions
Before making gas connections ensure that the appliance being installed is compatible with the available gas type.
Any natural or propane gas conversions necessary to meet the appliance and locality needs must be made by a qualified technician using Hearth & Home Technologies specified and approved parts.
PILOT HOOD
MILLIVOT GENERATOR
THERMOCOUPLE
ALIGNMENT NOTCH
1. Converting to LP Gas
NOTE: Gas conversions should only be performed by a qualified service person, and/or where required by state and local codes, licensed installer/service technician. In the Commonwealth of Massachusetts, installation must be performed by a licensed plumber or gas fitter.
Any damaged valve components should not be installed. If a valve or regulator has been dropped or appears to have been modified, the valve or regulator should not be installed.
KIT CONTENTS: Replacement orifice; replacement pilot injector; valve regulator; and conversion label.
TOOLS REQUIRED: #2 Phillips head screwdriver, slot- ted screwdriver or Torx TH20; 5/32 in. Allen wrench; 3/8 in. open end wrench.
Remove 2 screws
Figure 6.1 Remove top and front (if installed), glass, and logs (if installed). Remove burner by removing ONLY the two screws indicated. DO NOT remove the screws from the burner top. Lift the burner up and out of the firebox.
Figure 6.2 Pull off pilot hood and set aside. Do not remove
the wire clip.
5/32 in. Allen wrench
Figure 6.3 Use a 5/32 in. Allen wrench to remove the pilot injector. Replace pilot injector with the one supplied with the appliance (#35 for Propane, #62 for Natural Gas).
Replace pilot hood, snapping into position.
Figure 6.4 Remove main burner orifice using a 3/8 in. wrench. Be sure to align notch on left side of pilot hood, shown. Replace orifice with the proper size as indicated below for your gas type and venting.
PROPANE | NATURAL GAS |
#56#49
Reinstall burner.
August 1, 2008 | Heat & Glo · Tiara Petite B · | Page 25 |
