2 Getting Started
A. Design & Installation Considerations
Heat & Glo direct vent gas appliances are designed to oper- ate with all combustion air drawn from outside of the building and all exhaust gases expelled to the outside. No additional air source is required.
CAUTION
Check building codes prior to installation.
•Installation MUST comply with local, regional, state and national codes and regulations.
•Consult local building, fire officials or authorities having jurisdiction about restrictions, installation inspection, and permits.
When planning an installation, it is necessary to determine the following information before installing:
•Where the appliance is to be installed.
•The vent system configuration to be used.
•Gas supply piping.
•Electrical wiring.
•Whether optional accessories - devices such as a blower, thermostat or remote control - are desired.
WARNING
Keep appliance dry.
•Mold or rust may cause odors.
•Water may damage controls.
B.Tools and Supplies Needed
Before beginning the installation be sure that the following tools and building supplies are available. Note: Not all tools will apply to every installation.
Reciprocating saw | Variable Speed Drill/Driver |
Pliers | Wrench Set |
Hammer | Framing Square |
Phillips Screwdriver | Framing Material |
Flat Blade Screwdriver | Hi temp caulking material |
Plumb Line | Voltmeter |
Level | Gloves |
Manometer | Safety Glasses |
Tape Measure | |
| or combustible gas detector |
C. Inspect Appliance & Components
WARNING
Inspect appliance and components for damage. Damaged parts may impair safe operation.
•Do NOT install damaged components.
•Do NOT install incomplete components.
• Do NOT install substitute components.
Report damaged parts to dealer.
•Carefully remove the appliance and components from the packaging.
•Remove cast door and glass door, and set aside on pro- tective surface.
•Remove log set and component pack from firebox.
•Report to your dealer any parts damaged in shipment, particularly the condition of the glass.
•Read all of the instructions before starting the instal- lation. Follow these instructions carefully during the installation to ensure maximum safety and benefit.
WARNING
Hearth & Home Technologies disclaims any responsibility for, and the warranty will be voided by, the following actions:
•Installation and use of any damaged appliance or vent system component.
•Modification of the appliance or vent system.
•Installation other than as instructed by Hearth & Home Technologies.
•Improper positioning of the gas logs or the glass door.
•Installation and/or use of any component part not approved by Hearth & Home Technologies.
Any such action may cause a fire hazard.
Page 6 | Heat & Glo · Tiara Petite B · | August 1, 2008 |
