Paradyne 6800 manual Itoh C-240

Preparing the Printers

C.ITOH C-240

The C.ITOH C-240 is a dot matrix printer that communicates with the host processor through a serial interface. Five functions must be modified to properly communicate with the host processor. Table 3-6 provides the information for modifying these functions. The NMS Status in the table is the setting to which the given function will be changed.

Table 3-6

C.ITOH C-240 Setting Changes

Function	Function	Menu No.	Default Status	Menu No.	NMS Status
No.
01	EMULATION	01	IBM PRO PRINTER	02	EPSON FX-800
			XL
18	SKIP	02	INVALID	01	VALID
	PERFORMANCE
22	TEAR OFF	02	VALID (1SEC)	01	INVALID
28	INTERFACE	01	PARALLEL	02	SERIAL
29	PROTOCOL	01	READY/BUSY	02	XON/OFF

To modify printer functions, perform the following steps:

1.While holding down the FM button, press the POWER button on the right side of the printer to turn on the power. When you release the FM button, the SET UP mode is selected. All the current function settings are printed, then FUNC. NO. 01 is printed.

2.Press the LF button the appropriate number of times to select the function you want to change. The NLQ-1 lamp is on.

3.Press the FM button. MENU Select mode is selected. No printing occurs. The NLQ-2 lamp turns on.

4.Press the LF button to select the appropriate MENU NO. For example, with the SKIP PERFORATION function, you would press the LF button once to select 01 (VALID).

5.Press the FM button to return to Function Select Mode. Repeat Steps 2 through 5 as many times as needed to cycle through the functions and their associated menu items. When all changes required as indicated by Table 3-6 have been entered, go to Step 6.

6.Press the ENTER button. This exits the SET UP mode and returns the printer to the normal printing mode state. No printing occurs.

6800-A2-GN22-30 January 1997 3-17