Paradyne 6800 manual Fujitsu DL3400, DL3400 Ð Front Control Panel

Preparing the Printers

Fujitsu DL3400

The Fujitsu DL3400 is a multicolor, 24-pin dot matrix printer. This printer communicates with the host processor through a parallel (Centronics) interface. The interface cable receptacle is positioned at the right rear corner of the printer.

To modify the default settings, you use the buttons on the front control panel. This panel is shown in Figure 3-2.

To modify the default settings, perform the following steps:

1.Connect the power cable to the printer and plug the power cable into an outlet Ð but do not turn the power on yet. Load 13.5 inch-wide continuous form paper into the printer. (For detailed instructions, consult the Fujitsu DL3300/3400 Printer User's Manual that comes with the machine.)

2.To modify the printer's default settings, you must be in SETUP mode. To put the printer in SETUP mode, press the MODE button on the front control panel and Ð while continuing to hold the MODE button down Ð turn the printer's power on.

The MODE indicator on the front panel will light, and the SETUP mode opening menu will be printed. This menu is shown in Figure 3-3 (to view the menu, pull the clear plastic front cover completely forward).

3.SETUP mode consists of a number of functions. The first function is referred to as MENU1. To access this function, press the MODE button until the cursor is positioned next to MENU1.

The MENU1 function consists of 22 individual printer settings. These settings are shown below, along with the correct value for each setting.

POWER On Indicator	POWER
	PAPER OUT
		ONLINE
	LETTER	Pushbuttons
Status Indicators	FONT1	FF
	MENU1
	DRAFT
	FONT2	LF
	MENU2
		MODE
		492-12819-02

Figure 3-2. DL3400 Ð Front Control Panel

6800-A2-GN22-30 January 1997 3-5