Paradyne 6800 manual Select Start Address and Press Enter, Type any key to proceed. Press Enter

COMSPHERE 6800 Series Network Management System

8.Select Start Address and PRESS: Enter

9.Select the Correct Window size/address combination and PRESS: Enter

Addresses are listed in Table 2-1 (for 5000 host) and Table 2-5 (for 15000 host). (All window sizes for the EMULEX DCP/MUXi cards are 16KB.) The Select Window Size menu is displayed.

10.Select 16KB and PRESS: Enter

11.Exit the configuration menu and return to the Main Menu: PRESS: Esc

12.Select Run and PRESS: Enter

NOTE

The EMULEX DCP/MUXi diagnostics automatically test to see if the local processor can interrupt the host. The EMULEX DCP/MUXi cards are configured without using interrupts. The diagnostics will erroneously flag this as an error. This is not an error, so ignore the error message.

13.The system prompts:

Local processor did not interrupt host --> FAIL

***Pausing on error ---> Type any key to continue: PRESS: Enter

14.When the diagnostics are completed, the system prompts:

Type any key to proceed. PRESS: Enter

The Main Menu is displayed. To test a second EMULEX DCP/MUXi card or to repeat the test, return to Step 5. Otherwise, continue.

15.Select Exit and PRESS: Enter

16.At the DOS prompt, remove the floppy disk and PRESS: Ctrl + Alt + Del

to reboot the system or run the next DOS-based diagnostics program.

8-14 January 1997 6800-A2-GN22-30