Paradyne 6800 manual 240, Connecting the Dedicated Automatic Trouble Report Printer

Connecting the Components

2.Connect the other end of the 035-0153-0031 cable to the 002-0040-0031 connector.

3.Connect the 002-0040-0031 connector to the RS-232 serial port on the DX2300.

C-240

The C.ITOH C-240 can be connected to the COM1 or COM2 serial ports or to an available serial port on the IPC-1600 card in the host processor. Perform the following steps to connect this printer:

1.Connect the grounded end of the 035-0152-0031 cable to an available port on the IPC-1600 card in the host processor. Use the 002-0054-0031 connector if you are connecting to a COM port on the host processor.

2.Connect the other end of the 035-0153-0031 cable to the 002-0040-0031 connector.

3.Connect the 002-0040-0031 connector to the RS-232 serial port on the back of the C-240 printer.

Connecting the Dedicated Automatic Trouble Report Printer

The Automatic Trouble Report (ATR) feature is primarily used to send alert reports to the Paradyne technical assistance center. The dedicated ATR printer can be used locally if the customer requires a duplicate copy of alert reports. This local printer is the Fujitsu DX2300 or C.ITOH C-240. The diagram in Figure 4-12 illustrates the dedicated ATR printer connection.

To set up the dedicated ATR printer, perform the following steps.

1.Connect the grounded end of the 035-0153-0031 cable to an available port on the IPC-1600 card in the host processor.

2.Connect the other end of the 035-0153-0031 cable to the 002-0039-0031 connector.

3.Connect the 002-0040-0031 connector to the serial port of the dedicated ATR printer.

Refer to Appendix A, Modem Settings, for information on optioning the 3810, 38811, 3820, or 2224CEO modems.

6800-A2-GN22-30 January 1997 4-21