8.Attach the Backrest (8) to the Backrest Bracket (3) with three M6 x 38mm Button Screws (72) and three M6 Washers (44). Start all three Button Screws before you tighten any of them.
9.Push the seat handle down. Pull the Seat Carriage (41) towards the back of the exercise cycle until it stops. Then, pull up on the seat handle to lock the Seat Carriage in place.
While another person holds the Seat Bracket (11) near the Seat Carriage (41), connect the Right Controller Wire (82), which has a tag attached, to the wire on the Rear Wire Harness (51) that has a tag attached. Then, connect the Left Controller Wire (61) to the other wire on the Rear Wire Harness. Make sure that the con- nectors on the Controller Wires (61, 82) are posi- tioned side by side under the plastic cover on the Seat Bracket.
Be careful to avoid pinching and damaging the wires. Attach the Seat Bracket (11) to the Seat Carriage (41) with four M8 x 19mm Button Screws (77) and four M8 Split Washers (55).
8 |
|
|
8 |
|
|
3 | 44 | 72 |
44 | 44 | |
72 |
| |
|
| |
9 
Avo
i
d pinching and 
damaging the wires.
|
|
| 55 | 77 |
11 |
| 61 | Plastic | |
| 82 | Cover | ||
77 | 55 |
| Seat | |
| 41 | Handle | ||
|
|
|
| 51 |
8
