Hardware Installation

Connecting the Printer

One parallel printer cable is required to connect the printer.

Follow these steps to connect the printer:

1.Unpack and set up the printer according to the instructions in the documentation supplied with the printer. Do not plug in the printer.

2.Connect the 25-pin DB25 connector end of the parallel printer cable to the parallel port on the WGS system module. The cable connector has pins and the WGS connector has sockets. Secure the connector with the captive screws.

3.Connect the other end of the parallel printer cable to the matching Centronics® port (Amphenol connector) on the printer. Use the spring clips to secure it.

4.Plug in the printer.

2-64

Page 84
Image 84
AT&T 2.1.1 manual Connecting the Printer