Hardware Installation

Connecting Voice and Data Lines

Voice lines must be connected to the IVP4 board(s) and a data line must be connected to the DCP board if it is used.

Connecting the IVP Voice Lines

Each IVP4 board has two 6-position modular jacks. Each of these modular jacks is used to connect two voice lines in the RJ14C configuration. The top jack is used for line pairs 1 and 2. The bottom jack is used for line pairs 3

and 4.

If the line pairs are run two per jack (RJ14C), use two standard, 4-conductor modular cables.

If the line pairs are run individually (RJ11 C), a type 884A adapter maybe used to consolidate the four individual line pairs into two pairs (RJ14C) in each of two cables.

CAUTION:

There is a magnet on the back of the 884A adapter. Be sure that you do not place this near the hard disk drive or floppy disks.

2-59

Page 79
Image 79
AT&T 2.1.1 manual Connecting Voice and Data Lines, Connecting the IVP Voice Lines