Software Installation
Installing Cartridge Tape Utility Software
If you have a cartridge tape drive, you must install the Cartridge Tape Utility software.
NOTE:
The tape drive is not compatible with the DCP board.
Use the following procedures to install the cartridge tape utility software:
1.Log in as root (if you are not already logged in).
2.At the # prompt, type installpkg and press (Enter).
For systems with an installed tape drive: | . |
| |
— The system displays |
|
Please indicate the installation medium you intend to use.
Strike C to install from CARTRIDGE TAPE or F to install from FLOPPY DISKETTE.
Strike ESC to stop.
— Type f.
For systems with more than one floppy disk drive:
—The system displays
This system has two floppy drives. Strike ENTER to install from drive 0 or 1 to install from drive 1.
—Type 1 and press (Enter) to select drive 1, or just press (Enter) to select drive 0.
NOTE:
If the system configuration includes a tape drive or multiple floppy disk drives, additional prompts may appear. Use the preceding steps as a guide to responding to the system prompts. The actual prompts may vary depending on the system configuration.
