AT&T 2.1.1 manual Connecting the DCP Data Line, Setting Up a Report Printer, Hardware Installation

Hardware Installation

Connecting the DCP Data Line

The DCP board is used to obtain digital data from telephone systems that use DCP. There are three 8-position modular jacks on the back of the board labeled “phone,“ “line,” and “other.” The data circuit should be connected to the jack labeled “line.” Use standard D8W cable.

A single port on a digital ports board in the telephone switch is required to provide the data to the DCP board. An available port on an existing board may be used. Otherwise, an additional digital ports board must be installed in the switch. Consult the switch documentation for information on installing boards and wiring to that end of the data connection.

Setting Up a Report Printer

AUDIX Voice Power supports the AT&T 470/471 and 570/571 printers. This section describes the setup of the AT&T 570 (80 column) or 571

(132 column) printer. For other printers, please refer to the documentation received with the printer.

The switches and lamps have different meanings in Set Up Mode than they do in NormalPrint Mode. The printer operation panel is shown in Figure 2-36with the setup functions identified.

Figure 2-36. Printer Operation Panel

2-61