Configuration Testing and Troubleshooting
General Diagnostics
The only general diagnostics other than the POST are those provided on
the Customer Test disk for testing the basic system integrity. Additional
diagnostics for the IVP4 boards run under the application software.
To run the Customer Test diagnostics, follow these steps:
1.
2.
3.
4.
5.
Insert the Customer Test disk supplied with the system into floppy
disk drive A.
NOTE:
Be sure to shut down the UNIX system before rebooting.
Boot the system by turning power ON or by pressing (Reset) if the
power is already on.
The system boots from the Customer Test disk and displays the
Customer Test introduction screen.
Press (Enter) to continue.
The Customer Test main menu appears.
Use
All Modules
(the command displayed depends on the processor
to move the highlight bar to System Checkout or Test
that you are using) and press (Enter).
NOTE:
If
Test All Modules
appears on the main menu,
Customization Screen
will also appear. On the
Customization Screen, the interactive mode must be set to
ON before you select
Test All Modules
if the speaker
test, floppy disk drive test, keyboard keystrokes and
typematic tests, and mouse tests are to be performed. If the
interactive mode is OFF, these tests will not be performed.
Follow the directions on the screen to run the diagnostics.
4-6