Nortel Networks TP-1610 SIP Status & Diagnostic, Changing the Mediant 2000 Username and Password

Mediant 2000 SIP User’s Manual 5. Web Management

7.To save the loaded auxiliary files so they are available after a power fail, refer to Section 5.12 on page 84.

8.To reset the Mediant 2000, refer to Section 5.12 on page 84.

5.9.7Changing the Mediant 2000 Username and Password

To prevent unauthorized access to the Mediant 2000, it is recommended that you change the username and password (both are case-sensitive) that are used to access the Web Interface.

To change the username and password, take these 5 steps:

1.Open the ‘Change Password’ screen (Advanced Configuration menu > Change Password); the ‘Change Password’ screen is displayed.

Figure 5-21: Change Password Screen

2.In the ‘User Name’ and ‘Password’ fields, enter the new username and the new password respectively. Note that the username and password can be a maximum of 7 case-sensitive characters.

3.In the ‘Confirm Password’ field, reenter the new password.

4.Click the Change Password button; the new username and password are applied and the ‘Enter Network Password’ screen appears, shown in Figure 5-1on page 41.

5.Enter the updated username and password in the ‘Enter Network Password’ screen.

5.10Status & Diagnostic

Use this menu to view and monitor the gateway’s channels, Syslog messages, hardware / software product information, and to assess the gateway’s statistics and IP connectivity information.

5.10.1 Gateway Statistics

Use the screens under Gateway Statistics to monitor real-time activity such as IP Connectivity information, call details and call statistics, including the number of call attempts, failed calls, fax calls, etc.

Note: The Gateway Statistics screens doesn’t refresh automatically. To view updated information re-access the screen you require.

5.10.1.1 IP Connectivity

The IP Connectivity screen provides you with an online read-only network diagnostic connectivity information on all destination IP addresses configured in the Tel to IP Routing table.

Note: This information is available only if the parameter ‘AltRoutingTel2IPEnable’ (described in Table 6-5)is set to 1 (Enable) or 2 (Status Only).

Version 4.4 71 July 2005