Nortel Networks TP-1610 SIP To view the IP connectivity information, take these 2 steps

Mediant 2000 SIP

Note: The information in columns ‘Quality Status’ and ‘Quality Info.’ (per IP address) is reset if two minutes elapse without a call to that destination.

To view the IP connectivity information, take these 2 steps:

1.Set ‘AltRoutingTel2IPEnable’ to 1 or 2.

2.Open the ‘IP Connectivity’ screen (Status & Diagnostics menu > Gateway Statistics submenu > IP Connectivity); the ‘IP Connectivity’ screen is displayed (Figure 5-22).

Figure 5-22: IP Connectivity Screen

		Table 5-8: IP Connectivity Parameters
Column Name	Description
IP Address	IP address defined in the destination IP address field in the Tel to IP Routing table.
	or
	IP address that is resolved from the host name defined in the destination IP address field in the
	Tel to IP Routing table.
Host Name	Host name (or IP address) defined in the destination IP address field in the Tel to IP Routing
	table.
Connectivity Method	The method according to which the destination IP address is queried periodically (currently
	only by ping).
Connectivity Status	Displays the status of the IP address’ connectivity according to the method in the ‘Connectivity
	Method’ field.
	Can be one of the following:
	•	OK	= Remote side responds to periodic connectivity queries.
	•	Lost	= Remote side didn’t respond for a short period.
	•	Fail	= Remote side doesn’t respond.
	•	Init	= Connectivity queries not started (e.g., IP address not resolved).
	•	Disable	= The connectivity option is disabled (‘AltRoutingTel2IPMode’ equals 0 or 2).
Quality Status	Determines the QoS (according to packet loss and delay) of the IP address.
	Can be one of the following:
	•	Unknown	= Recent quality information isn’t available.
	•	OK
	•	Poor
	Note 1: This field is applicable only if the parameter ‘AltRoutingTel2IPMode’ is set to 2 or 3.
	Note 2: This field is reset if no QoS information is received for 2 minutes.
Mediant 2000 SIP User’s Manual			72	Document #: LTRT-72504