Mediant 2000 SIP User’s Manual

11. SNMP-Based Management

Figure 11-1: Example of Entries in a Device ini file Regarding SNMP

;SNMP trap destinations

;The board maintains a table of trap destinations containing 5 ;rows. The rows are numbered 0..4. Each block of 4 items below ;apply to a row in the table.

;To configure one of the rows, uncomment all 4 lines in that ;block. Supply an IP address and if necessary, change the port ;number.

;To delete a trap destination, set ISUSED to 0.

;-change these entries as needed

;SNMPManagerTableIP_0= ;SNMPManagerTrapPort_0=162 ;SNMPManagerIsUsed_0=1 ;SNMPManagerTrapSendingEnable_0=1

;

;SNMPManagerTableIP_1= ;SNMPManagerTrapPort_1=162 ;SNMPManagerIsUsed_1=1 ;SNMPManagerTrapSendingEnable_1=1

;

;SNMPManagerTableIP_2= ;SNMPManagerTrapPort_2=162 ;SNMPManagerIsUsed_2=1 ;SNMPManagerTrapSendingEnable_2=1

;

;SNMPManagerTableIP_3= ;SNMPManagerTrapPort_3=162 ;SNMPManagerIsUsed_3=1 ;SNMPManagerTrapSendingEnable_3=1

;

;SNMPManagerTableIP_4= ;SNMPManagerTrapPort_4=162 ;SNMPManagerIsUsed_4=1 ;SNMPManagerTrapSendingEnable_4=1

Note: The same information configurable in the ini file can also be configured via the acBoardMIB.

11.6.4.2 Configuration via SNMP

To configure trap destinations, the EM must use the snmpTargetMIB. Up to 5 trap destinations can be configured.

To add a trap destination:

Add a row to the snmpTargetAddrTable with these values:

Name=trapN, TagList=AC_TRAP, Params=v2cparams, where N is an unused number between 0 and 4.

All changes to the trap destination configuration take effect immediately.

To delete a trap destination:

Remove the appropriate row from the snmpTargetAddrTable.

To modify a trap destination:

(You can change the IP address and/or port number for an existing trap destination. The same effect can be achieved by removing a row and adding a new row).

Modify the IP address and/or port number for the appropriate row in the snmpTargetAddrTable.

Version 4.4

181

July 2005

Page 181
Image 181
Nortel Networks TP-1610 SIP user manual Configuration via Snmp, To add a trap destination, To delete a trap destination