Nortel Networks TP-1610 SIP ISDNGeneralCCBehavior, ISDNOutCallsBehavior, ISDNIBehaviorx

Mediant 2000 SIP User’s Manual 6. ini File Configuration of the Mediant 2000

Table 6-6: E1/T1/J1 Configuration Parameters (continues on pages 122 to 127)

ini File Field Name		Valid Range and Description
Web Parameter Name*
ISDNGeneralCCBehavior		16 = The gateway clears down the call if it receives a Notify message specifying
[General Call Control Behavior]		‘User-Suspended’. A Notify (User-Suspended) message is used by some networks
		(e.g., in Italy or Denmark) to indicate that the remote user has cleared the call,
		especially in the case of a long distance voice call.
		32 = Applies only to ETSI E1 lines (30B+D). Enables handling the differences
		between the newer QSIG standard (ETS 300-172) and other ETSI-based standards
		(ETS 300-102 and ETS 300-403) in the conversion of B-channel ID values into
		timeslot values:
		• In ‘regular ETSI’ standards, the timeslot is identical to the B-channel ID value,
		and the range for both is 1 to 15 and 17 to 31. The D-channel is identified as
		channel-id #16 and carried into the timeslot #16.
		• In newer QSIG standards, the channel-id range is 1 to 30, but the timeslot range
		is still 1 to 15 and 17 to 31. The D-channel is not identified as channel-id #16,
		but is still carried into the timeslot #16.
		When this bit is set, the channel ID #16 is considered as a valid B-channel ID, but
		timeslot values are converted to reflect the range 1 to 15 and 17 to 31. This is the
		new QSIG mode of operation. When this bit is not set (default), the channel_id #16 is
		not allowed, as for all ETSI-like standards.
ISDNOutCallsBehavior		1024 = Numbering plan / type for T1 IP Tel calling number are defined according to
[Outgoing Calls Behavior]		the manipulation tables or according to RPID header (default). Otherwise, the Plan /
		type for T1 calls are set according to the length of the calling number
ISDNIBehavior_x		Same as the description for parameter ‘ISDNBehavior’ for a specific trunk ID (x = 0 to
[Q.931 Layer Response
	7)
Behavior]
ISDNInCallsBehavior_x		Same as the description for parameter ‘ISDNInCallsBehavior’ for a specific trunk ID
[Incoming Calls Behavior]		(x = 0 to 7)
ISDNOutCallsBehavior_x		Same as the description for parameter ‘ISDNOutCallsBehavior’ for a specific trunk ID
[Outgoing Calls Behavior]		(x = 0 to 7)

Version 4.4 127 July 2005