Nortel Networks TP-1610 SIP Configuring the Trunk Group Settings, Trunk Group Settings Screen

Mediant 2000 SIP

5.8.7Configuring the Trunk Group Settings

The Trunk Group Settings Table is used to determine the method in which new calls are assigned to B-channels within each trunk group. If such a rule doesn’t exist (for a specific Trunk group), the global rule, defined by the Channel Select Mode parameter (Protocol Definition > General Parameters), applies.

To configure the Trunk Group Settings table, take these 7 steps:

1.Open the ‘Trunk Group Settings’ screen (Protocol Management menu > Trunk Group Settings); the ‘Trunk Group Settings’ screen is displayed.

Figure 5-13: Trunk Group Settings Screen

2.In the Routing Index drop-down list, select the range of entries that you want to edit (up to 24 entries can be configured).

3.In the Trunk Group ID field, enter the Trunk Group ID number.

4.In the Channel Select Mode drop-down list, select the Channel Select Mode that determines the method in which new calls are assigned to B-channels within the Trunk groups entered in the field to the right of this field. For information on available Channel Select Modes, refer to Table 5-6.

5.Repeat steps 4 and 5, for each defined Trunk group.

6.Click the Submit button to save your changes.

7.To save the changes so they are available after a power fail, refer to Section 5.12 on page 84.

Mediant 2000 SIP User’s Manual 60 Document #: LTRT-72504