Nortel Networks TP-1610 SIP user manual Table L-3 acBoardTemperatureAlarm Alarm Trap

Mediant 2000 SIP

Table L-2: acBoardConfigurationError Alarm Trap

Corrective Action:

Inspect the run-time specific string to determine the nature of the configuration error. Fix the configuration error using the appropriate tool: Web interface, EMS, or ini file. Save the configuration and if necessary reset the device.

	Table L-3: acBoardTemperatureAlarm Alarm Trap
Alarm:		acBoardTemperatureAlarm
OID:		1.3.6.1.4.1.5003.9.10.1.21.2.0.3
Default Severity		Critical
Event Type:		equipmentAlarm
Probable Cause:		temperatureUnacceptable (50)
Alarm Text:		Board temperature too high
Status Changes:
Condition:		Temperature is above 60 degrees C (140 degrees F)
Alarm status:		Critical
Condition:		After raise, temperature falls below 55 degrees C (131 degrees F)
Alarm status:		Cleared
Corrective Action:		Inspect the system. Determine if all fans in the system are properly operating.

	Table L-4: acBoardEvResettingBoard Alarm Trap
Alarm:		acBoardEvResettingBoard
OID:		1.3.6.1.4.1.5003.9.10.1.21.2.0.5
Default Severity		Critical
Event Type:		equipmentAlarm
Probable Cause:		outOfService (71)
Alarm Text:		User resetting board
Status Changes:
Condition:		When a soft reset is triggered via the Web interface or SNMP.
Alarm status:		Critical
Condition:		After raise
Alarm status:		Status stays critical until reboot. A clear trap is not sent.
Corrective Action:		A network administrator has taken action to reset the device. No corrective action is
		required.

	Table L-5: acFeatureKeyError Alarm Trap
Alarm:	acFeatureKeyError
OID:	1.3.6.1.4.1.5003.9.10.1.21.2.0.6
Default Severity	Critical
Event Type:	processingErrorAlarm
Probable Cause:	configurationOrCustomizationError (7)
Alarm Text:	Feature key error
Status Changes:
Note:	Support of this alarm is pending
Condition:	A feature key error has been detected
Alarm status:	Critical
Mediant 2000 SIP User’s Manual		272	Document #: LTRT-72504