MicroNet Technology MN100 manual Alarms Chapter

Setup and Calibration

(s9) LOG UNITS

The units in which ALL distance related information is displayed. Nautical Miles (NM), Kilometres (KM) or Statute Miles (SM).

(s10) TEMP UNITS

The units in which the Sea Temperature reading is displayed. Degrees Celsius (0C) or Degrees Fahrenheit (0F).

3.4.3 Alarms Chapter

In each case press the button quickly to edit, press the or

to change values and press the button quickly to save the

entered value. In the case of On/Off selection the button will toggle the setting On and Off. Default values are indicated in bold.

(s11) DEPTH SHALL

Sets the Shallow Depth at which the instrument will alarm. OFF and 0 to 7.6m (0 to 25 ft.) (0 to 4 ftms). Values are displayed in the previously selected units (see page 18 -s7) and are all subject to any keel or waterline offset added (see page 20 -s21). This alarm sounds as the depth passes below the set value and NOT as the depth increases past this value.

(s12) DEPTH DEEP

Sets the Deep Depth at which the instrument will alarm. OFF and 0 to 76.2m (0 to 250 ft.) (0 to 41.6 ftms). Values are displayed in the selected units (see page 18 -s7) and are all subject to any keel or waterline offset added (see page 23). This alarm sounds as the depth increases past this value or decreases past this value.

(s13) OFF CRSE

Sounds if the vessel moves further than the set distance away from a “Locked” heading (see page 19 -s12). Off/On

(s14) WIND HIGH

Sets the Wind Speed at which the instrument will alarm. OFF and 0.0 to 100 knots (0.0 to 51.4 m/s). Values are displayed in the previously selected units (see page 18 -s8). This alarm sounds as the wind speed increases past the set value and NOT as it decreases past this value.

21