Nortel Networks TP-1610 SIP PSTNAlertTimeout, ISDNTransferCapability, ScreeningInd2IP, EnableCIC

Mediant 2000 SIP User’s Manual 6. ini File Configuration of the Mediant 2000

Table 6-4: ISDN and CAS Interworking-Related Parameters (continues on pages 111 to 114)

ini File Field Name		Valid Range and Description
Web Parameter Name*
PSTNAlertTimeout	Alert Timeout in seconds (ISDN T301 timer) for outgoing calls to PSTN.
[PSTN Alert Timeout]	The default is 180 seconds. The range is 0 to 240.
	Note: The PSTN stack T301 timer can be overridden by a lower value, but it can’t be
	increased.
ISDNTransferCapability	Defines the IP ISDN Transfer Capability of the Bearer Capability IE in ISDN Setup
[ISDN Transfer Capabilities]	messages.
	0	= Audio 3.1 (default).
	1	= Speech.
	2	= Data.
	Note: If this parameter isn’t configured or equals to ‘–1’, Audio 3.1 capability is used.
ScreeningInd2IP	The parameter can overwrite the calling number screening indication for ISDN Tel IP
[Send Screening Indicator to	calls.
IP]	-1 = not configured (interworking from ISDN to IP) or set to 0 for CAS.
	0	= user provided, not screened.
	1	= user provided, verified and passed.
	2	= user provided, verified and failed.
	3	= network provided.
	Note: Applicable only if Remote Party ID (RPID) header is enabled.
SupportRedirectInFacility	0	= Not Supported (default).
	1	= Supports partial retrieval of Redirect Number (number only) from a Facility IE in
	ISDN Setup messages. Applicable to Redirect number according to ECMA-173 Call
	Diversion Supplementary Services.
	Note: To enable this feature, ‘ISDNDuplicateQ931BuffMode’ must be set to 1.
EnableCIC	0	= Do not relay the Carrier Identification Code (CIC) to ISDN (default).
	1	= CIC is relayed to ISDN in Transit Network Selection IE.
	If enabled, the CIC code (received in an Invite Request-URI) is included in a TNS IE in
	ISDN Setup message. For example: INVITE sip:555666;cic=2345@100.2.3.4 sip/2.0.
	Note: Currently this feature is supported only in SIP ISDN direction.
EnableAOC	0	= Not used (default).
	1	= ISDN Advice of Charge (AOC) messages are interworked to SIP.
	The gateway supports reception of ISDN (Euro ISDN) AOC messages. AOC messages
	can be received during a call (Facility messages) or at the end of a call (Disconnect or
	Release messages). The gateway converts the AOC messages into SIP Info (during a
	call) and Bye (end of a call) messages using a proprietary AOC SIP header. The
	gateway supports both Currency and Pulse AOC messages.
TimeForReorderTone	Busy or Reorder Tone duration the CAS gateway plays before releasing the line.
	The valid range is 0 to 15. The default value is 10 seconds.
	Applicable also to ISDN if ‘PlayBusyTone2ISDN = 2’. Selection of Busy or Reorder tone
	is done according to release cause received from IP.
DisconnectOnBusyTone	0	= Do not disconnect call on detection of busy tone
[Disconnect Call on Detection	1	= Disconnect call on detection of busy tone (default).
of Busy Tone]	This parameter is applicable to CAS & ISDN protocols.
PlayBusyTone2ISDN	This parameter enables the Mediant 2000 ISDN gateway to play a Busy or a Reorder
[Play Busy Tone to Tel]	tone to the PSTN after a call is released.
	0	= Immediately sends an ISDN Disconnect message (default).
	1	= Sends an ISDN Disconnect message with PI=8 and plays a Busy or a Reorder tone
	to the PSTN (depending on the release cause).
	2	= Delays the sending of an ISDN Disconnect message for ‘TimeForReorderTone’
	seconds and plays a Busy or a Reorder tone to the PSTN. Applicable only if the call is
	released from the IP before it reaches the Connect state. Otherwise, the Disconnect
	message is sent immediately and no tones are played.
TrunkTransferMode_X	0	= Not supported (default).
	1	= Supports CAS NFA DMS-100 transfer.
	When a SIP Refer message is received, the gateway performs a Blind Transfer by
	executing a CAS Wink and dialing the Refer-to number to the Switch and then releasing
	the call.
	Note: A specific NFA CAS table is required.

Version 4.4 113 July 2005