Nortel Networks TP-1610 SIP user manual Activating the Internal Syslog Viewer

Mediant 2000 SIP

2.Click the submenu links to check/view a specific channel’s parameter settings.

Figure 5-26: Channel Status Details Screen

5.10.3 Activating the Internal Syslog Viewer

The Message Log screen displays Syslog debug messages sent by the gateway.

Note that it is not recommended to keep a ‘Message Log’ session open for a prolonged period (refer to the Note below). For prolong debugging use an external Syslog server, refer to Section

9.2on page 165.

Refer to the Debug Level parameter ‘GwDebugLevel’ (described in Table 6-1) to determine the Syslog logging level.

To activate the Message Log, take these 4 steps:

1.In the General Parameters screen under Advanced Parameters submenu (accessed from the Protocol Management menu), set the parameter ‘Debug Level’ to 5. This parameter determines the Syslog logging level, in the range 0 to 5, where 5 is the highest level.

2.Open the ‘Message Log’ screen (Status & Diagnostics menu > Message Log); the ‘Message Log’ screen is displayed.

Figure 5-27: Message Log Screen

Mediant 2000 SIP User’s Manual 76 Document #: LTRT-72504