Nortel Networks TP-1610 SIP user manual Basic, Logging, Web and Radius Parameters

Mediant 2000 SIP

6.6Basic, Logging, Web and RADIUS Parameters

Note: In Table 6-1, parameters in brackets are the format in the Embedded Web Server *.

Table 6-1: Basic, Logging, Web and RADIUS Parameters (continues on pages 90 to 97)

ini File Field Name			Valid Range and Description
Web Parameter Name*
EthernetPhyConfiguration	0		= 10 Base-T half-duplex
	1		= 10 Base-T full-duplex
	2		= 100 Base-TX half-duplex
	3		= 100 Base-TX full-duplex
	4		= auto-negotiate (Default)
		Auto-negotiate falls back to half-duplex mode (HD) when the opposite port is not in
		auto-negotiate, but the speed (10 Base-T, 100 Base -TX) in this mode is always
		configured correctly.
DHCPEnable	0		= Disable DHCP support on the gateway (default).
[Enable DHCP]	1		= Enable DHCP support on the gateway.
		After the gateway is powered up, it attempts to communicate with a BootP server. If a
		BootP server is not responding and if DHCP is enabled, then the gateway attempts to
		get its IP address and other network parameters from the DHCP server.
		Web Note: After you enable the DHCP Server (from the Web browser) follow this
		procedure:
		• Click the Submit button.
		• Save the configuration using the ‘Save Configuration’ button (before you reset
			the gateway). For information on how to save the configuration, refer to Section
			5.12 on page 84.
		• Reset the gateway directly (Web reset doesn’t trigger the BootP/DHCP
			procedure and the parameter DHCPEnable reverts to ‘0’).
		Note that throughout the DHCP procedure the BootP/TFTP application must be
		deactivated. Otherwise, the gateway receives a response from the BootP server
		instead of the DHCP server.
		Note: The DHCPEnable is a special "Hidden" parameter. Once defined and saved in
		flash memory, its assigned value doesn’t revert to its default even if the parameter
		doesn't appear in the ini file.
EnableDiagnostics	0		= No diagnostics (default)
	1		= Perform diagnostics
EnableLanWatchDog	0		= Disable LAN Watch-Dog (default).
[Enable LAN Watchdog]	1		= Enable LAN Watch-Dog.
		If LAN Watch-Dog is enabled, the gateway restarts when a network failure is
		detected.
DNSPriServerIP		IP address of the primary DNS server in dotted format notation.
[DNS Primary Server IP]
DNSSecServerIP		IP address of the secondary DNS server in dotted format notation.
[DNS Secondary Server IP]

Mediant 2000 SIP User’s Manual 90 Document #: LTRT-72504