AT&T 2.1.1 manual VDC600Board Configuration and Installation

Hardware Installation

VDC600Board

Configuration and Installation

The VDC600 is the AT&T equivalent of a Video Graphics Array (VGA) board.

N O T E :

The 6386/SX WGS has a video controller built into the motherboard. The VDC600 should not be used with the 6386/SX WGS.

The VDC should be installed in the leftmost expansion slot on desktop configurations or in the rearmost expansion slot on floor models. Follow the general instructions for installing expansion boards described in General Installation Instructions, later in this chapter.

N O T E :

The VDC600 must be installed in a 16-bit expansion slot.

The default settings are used for the DIP switch and jumpers on the Video Display Controller. The locations and settings are shown in Figure 2-24.For more information on default settings, see the Video Display Controller lnstallation Guide packed with the board.

2-36