AT&T 2.1.1 manual Running Setup from a Floppy Disk

Hardware Installation

Running SETUP from a Floppy Disk

To run the SETUP program from a floppy disk, follow these steps:

1.Shut down the UNIX system before rebooting.

2.Insert the Customer Test disk supplied with the system into drive A. If running SETUP on a 6386 or 6386E, use the Customer Diagnostics disk instead of the Customer Test disk.

3 . Boot the system by turning power ON or by pressing the (Reset) button if the system is already on.

The system boots from the Customer Test disk and displays the Customer Test introduction screen.

4.Press (Enter) to continue.

The Customer Test main menu appears.

2-56