Upgrade Procedures
To upgrade from AUDIX Voice Power Release 1.1 to Release 2.1.1, it is necessary to first upgrade from Release 1.1 to Release 2.0, and then to upgrade from Release 2.0 to Release 2.1.1.
The procedure for upgrading from AUDIX Voice Power Release 1.1 to Release 2.0 is described in the following section. The procedure for upgrading from AUDIX Voice Power Release 2.0 to Release 2.1.1 is described later. If you are upgrading from Release 1.1, continue with the following section. If you are upgrading from Release 2.0, skip to the appropriately titled section.
Upgrading from Release 1.1 to Release 2.0
The procedure for upgrading from AUDIX Voice Power Release 1.1 to Release 2.0 is outlined below. The exact procedure for each step is included in the step or described elsewhere, either in this chapter, or in other parts of this document. Note that you must reinstall the UNIX system as part of this procedure.
1.Using FORM A from the AT& T AUDIX™ Voice Power Planning Guide and Forms (Release 2.1. 1), record the current Service Type and Extension for each channel. To determine the current Service Type and Extension, you must display the Voice Equipment window, as described in the chapter Assigning Services to Channels in your Switch Notes document. For each channel, write down the Service Type (the Service field on the Voice Equipment window). After the upgrade is complete, you reassign Service Types and Extensions to all channels.
2.Log into the system as root.
3.Insert the AUDIX Voice Power Upgrade Utility disk into the disk drive.
