Software Installation

AUDIX Voice Power Switch Integration Software R2.1.1 (Please see the Switch Notes for your telephone system for the exact name of this software package.)

Remote Terminal Package

NOTE:

If you are upgrading AUDIX Voice Power from a previous release, see Chapter 5, Upgrade Procedures, before proceeding. The upgrade procedure will refer you to the necessary sections in this chapter.

If you are adding AUDIX Voice Power to an existing system, or if you are reinstalling application software after an unrecoverable failure, the UNIX operating system must be reinstalled before you can install or reinstall AUDIX Voice Power.

Verifying Hard Disk Size

Before beginning the software installation, you should verify the size of the hard disk. To determine the hard disk size, follow these steps:

1.Insert the Customer Test disk supplied with the system into drive A.

2.Boot the system by turning power ON or by pressing (Reset) if the system is already on.

The system boots from the Customer Test disk and displays the Customer Test introduction screen.

3.Press (Enter) to continue.

The Customer Test main menu appears.

4. Use

to move the cursor to Setup utility and press (Enter).

5.Record the hard disk size for later use.

6.Press (Esc) to exit.

7.Move the cursor to Exit the program and press (Enter).

8.At the Want to Quit? prompt, select Yes and press (Enter).

9.Remove the Customer Test disk.

3-3

Page 89
Image 89
AT&T 2.1.1 manual Verifying Hard Disk Size